Zinc Coated Drive Pin Galvanized Concrete Steel Pin Shoot Nail

Short Description:


Product Detail

DRIVE PIN
Material
high quality carbon steel
Head Diameter
7.6mm/.300″
Shank Diameter
3.7mm/.145″
Length
19mm,22mm,27mm
Surface
bright, galvanized ,zinc plated
Note:
1-Accessory:with 8mm dia. flute
 
2-knurled shank available

drive pin展示

Features:
1.Produced with high quality carbon steel.
2.The nails are widely used for home decoration,concrete or holding the aluminum alloy on the concrete.
3.Different size can meet different client requirement.
4.Use with gas nail gun or used in conjunction with the powder actuated tools

 

                                Drive Pins With Steel Washer                                                                                Metal Right Angle Ceiling Clip
MAIN POINTS
1. Special Steel Nailing depth: 20-30mm for concrete, 30-50mm for brick masonry, and 1-3.5mm for sheet steel

2. The steel nail shall be clamped with steel wire pliers for knocking, or the steel nail shall be nailed on the small wooden strip first, and then nailed into the collective. When the nail is caught by bare hands for knocking, the fingers shall be avoided to be damaged.
3. When special steel nails are knocked, the force shall be positive. When using a larger hammer, the knocking force shall be large and the number of knocks shall be as small as possible. The final hammering depth shall be deeper.
4. When nailing concrete with high grade (more than 200#), if possible, drill a hole with the depth of 1 / 5-1 / 3 of the depth of steel nailing.
5. Avoid flying of steel nails when knocking

  • Previous:
  • Next:

  • Write your message here and send it to us